Chaska, MN · SW Twin Cities metro Open Mon-Fri 8a-5p Veteran-owned · Family-run · Since 1996 (612) 369-1631

Glass Restoration · Burnsville, MN · Est. 1996

Glass Restoration in Burnsville, Minnesota.

Burnsville sits on the south side of the Minnesota River across from Bloomington, a Dakota County city of more than 64,000. It grew earlier than its neighbors to the south, so its housing is a full generation older than Lakeville's. Glass restoration for Burnsville homes. Shower enclosures, windows, glass tabletops. Mineral-deposit removal, surface polishing if the damage has set into the glass, and a hydrophobic sealer that holds for years. Burnsville is the mirror image of Lakeville. The bulk of the stock went up in the 1970s and 1980s: split-levels, ramblers and two-story colonials with 2-car attached garages as the standard, on slabs that are now forty to fifty years old. A 1990s layer sits around the edges, and the Heart of the City redevelopment added newer multi-family and townhomes near the center. Three-car garages exist but are the exception rather than the rule. That age profile means Burnsville estimates involve more prep and more honest assessment than the newer suburbs do.

Glass Restoration in Burnsville

What an install looks like in Burnsville.

Burnsville is where the prep work matters. Most of the city's garages were poured in the 1970s and 1980s, which means the slabs have taken forty-plus winters of salt off three highway corridors and, in a lot of cases, a coat of hardware-store epoxy somewhere along the way that is now lifting in sheets where the tires sit. That is a heavier grind than a Lakeville or Savage floor, and it changes the quote. It is also the situation where a proper polyurea system makes the biggest visible difference, because the starting point is so much worse. The kitchens tell the same story: 1980s and 1990s stone that has never been professionally restored.

Glass Restoration specifically in Burnsville

Shower enclosures in Burnsville are frequently original to a 1980s or 1990s bathroom, which means decades of hard-water deposits rather than a few years. Homeowners are often told the glass is beyond saving and needs replacing. Usually it does not: restoration removes the bonded mineral layer and a hydrophobic sealer keeps it from re-forming. Clear View was the first shop in the Twin Cities to offer professional glass scratch removal, which matters most on glass this old.

Neighborhoods we work in

  • Heart of the City
  • Crystal Lake
  • Sunset Pond
  • Alimagnet
  • Terrace Oaks
  • Cliff Fen
30+ YR Restoring surfaces Including glass since 1996
3 Scope tiers Spot, Full, and Periodic Maintenance
0 Subcontractors All work done in-house
A+ BBB rated Accredited since October 2005

Why replacement is almost always unnecessary in Burnsville

Why shower glass spots become permanent.

Hard water in Minnesota carries dissolved minerals (calcium, magnesium). Every time water dries on the glass, those minerals are left behind as deposits. Over time the deposits etch into the glass surface, creating a permanent rough texture that traps soap scum and looks foggy. Once the etching is set, regular cleaning won't remove it; professional restoration is needed.

Replacement The default assumption
  • Custom shower glass replacement: $2,000 to $5,000+
  • Days of demo and reinstall
  • Harsh acid-based cleaning attempts that fail and damage glass seals
  • Often unnecessary; restoration almost always works
Professional restoration + hydrophobic sealer What we install
  • Removes deposits and surface etching
  • Hydrophobic sealer prevents future spotting
  • Eco-friendly products; no harsh acids near your family or glass seals
  • Single visit, no demo or downtime, fraction of replacement cost

Replacement is rarely necessary. The exception is glass that's been chemically damaged by aggressive acid cleaners; in those cases, replacement may be the right call, and we'll tell you that at the in-home assessment.

Burnsville Pricing

Glass restoration pricing in Burnsville, MN.

Final price depends on the scope (one panel vs whole shower vs window set) and how deeply the mineral deposits have set into the glass. Ranges below are typical project totals. Quote is written and fixed once we have seen the glass in person.

Single shower panel or window

One panel or one large window

From $250 to $600
  • Most common for one-off jobs
  • Mineral removal + sealer
Get my number

Full shower enclosure

All panels of one shower

From $600 to $1,500
  • Most common scope
  • Full restoration + hydrophobic sealer
Get my number

Multi-shower or window project

Multiple showers, or full window set

From $1,400 to $3,500+
  • Whole-house or multi-bathroom projects
  • Bundle pricing if scheduled together
Get my number

Heavy mineral buildup or chemically-damaged glass takes longer. We assess the depth of the damage at the in-home visit and write a quote that holds.

The 6-step install

How we install your floor in Burnsville.

Same approach every project. The hydrophobic sealer is what separates a cleaning from a real restoration.

  1. 1

    In-home assessment and written quote

    Visit, assess the glass surfaces, determine how deeply the mineral deposits have set, and write a fixed quote on the right scope. Most assessments take 15 to 20 minutes.
  2. 2

    Mask and prepare the area

    Bathroom or window area protected against splash from the cleaning solution. Drains covered, fixtures masked, surrounding tile or trim protected.
  3. 3

    Mineral deposit removal

    Specialized cleaning solution worked into the glass to dissolve and lift mineral deposits. Multiple passes for heavy buildup. This step alone restores most glass that's been neglected for under 5 years.
  4. 4

    Surface polishing and scratch removal (if needed)

    If the deposits have etched into the glass, mechanical polishing removes the etched layer. Physical scratches from past attempts to scrub with abrasive pads can also be safely polished out, even scratches deep enough to feel with a fingernail. Clear View was the first shop in the Twin Cities to offer professional glass scratch removal, and the technique extends the life of glass that other restorers tell homeowners to replace. Not every project needs this step; we determine at the assessment whether polishing or scratch removal is required.
  5. 5

    Hydrophobic sealer application

    Hydrophobic sealer worked into the cleaned glass surface. The sealer bonds with the glass and makes water sheet off instead of beading and drying as spots. This is the step that makes the restoration last.
  6. 6

    Walk-through and care guide

    Final walk-through on the restored glass. Care guide: how to maintain the sealer (gentle squeegee after showers, mild cleaners only, never acidic). With basic maintenance, the sealer holds 2 to 4 years.

Burnsville questions

Common questions for Burnsville homeowners.

My Burnsville garage has old epoxy peeling off in sheets. Can you still coat it?
Yes, and it is one of the most common Burnsville projects. Failed hardware-store epoxy has to come off completely before anything goes down, which is what diamond grinding is for. Once the slab is ground back to clean concrete and the pits and joints are repaired, a polyurea basecoat bonds properly in a way the original coating never did. The peeling is a symptom of bad prep the first time, not a reason the floor cannot be coated.
Is a 1978 Burnsville garage slab worth coating or should it be replaced?
Almost always worth coating. Most slabs from that era are structurally sound underneath; what looks bad is surface damage, salt pitting near the door, hot-tire pickup and hairline cracking. All three are prep problems, not concrete problems. If a slab genuinely has settled, cracked beyond hairline or spalled deeply, we say so at the in-home assessment and point you to a concrete contractor rather than putting a finished surface over a failing one.
Does the extra prep on an older slab cost more?
It can, and it is written into the quote at the in-home estimate rather than added later. A slab with failed coating to remove and pitting to repair takes more grinding time and more repair material than a fifteen-year-old slab in Savage does. You will see that in the number before you agree to anything. The system that goes down on top is the same either way.
Do you cover the whole city, including the older neighborhoods near Crystal Lake?
Yes, all of Burnsville. Twenty miles, roughly thirty minutes via Hwy 13, on the standard service area with no travel adjustment. The older neighborhoods are where the most dramatic before-and-after results come from, because the starting condition is furthest from where it ends up.
Will the glass really stop spotting after restoration?
Yes, dramatically. Hydrophobic sealer causes water to sheet off the glass instead of beading and drying. With a quick squeegee after each shower, the glass stays clear for years. Without the sealer, mineral spots return within months in Minnesota water.
How long does the sealer last?
Typically 2 to 4 years on shower glass, longer on less-used windows. Reapplication (the Periodic Maintenance scope) keeps the protection going indefinitely.
What about already-replaced shower glass that's spotting again?
Same fix. New glass spots just as fast as old glass without a sealer. Restoration plus the hydrophobic sealer is the right path. Replacement is rarely the answer.
Can you restore frosted or textured glass?
Frosted and textured glass takes more care because the texture itself traps deposits. Restoration is possible but the result varies by the texture pattern. We assess at the in-home visit and tell you what to expect.
Can you remove scratches from glass?
Yes, and we were the first shop in the Twin Cities to offer professional glass scratch removal. Scratches caused by abrasive pads, razor blades, or hard-water residue cleaning attempts can be safely polished back to optical clarity, including scratches deep enough to feel with a fingernail. The technique requires the right equipment and trained hands, which is why most cleaning services and even some restoration shops still tell homeowners scratched glass has to be replaced. We assess each piece at the in-home visit and tell you honestly which scratches can be removed and which cannot.
How do I clean the glass after restoration?
Squeegee after each shower, mild non-acidic cleaner once a week, microfiber for spots. Avoid: vinegar, ammonia-based glass cleaners, anything acidic. The care guide covers this in detail.
Do you restore windows?
Yes. Window restoration is the same process: mineral removal, polishing if etched, hydrophobic sealing. Most common for sun-facing windows that have built up hard-water spots from sprinklers or weather.
What about glass shower doors with metal frames?
The glass restoration is straightforward. The metal frame and tracks also tend to build up deposits; we can clean those at the same visit as part of the scope.
How long does a typical project take?
Single shower panel: 1 to 2 hours. Full shower enclosure: 2 to 4 hours. Window sets scale with the count. Same-day in nearly every case.
Do you offer a warranty?
Yes. The HydroShield sealer application is backed by a 10-year written warranty covering the hydrophobic sealer performance. Walked through at the in-home estimate.

More in Burnsville

All the services we offer in Burnsville, MN.

Glass, granite, marble. All three restored by the same owner. Bundle pricing when multiple surface types are scheduled together.

Coatings in Burnsville

Other surfaces we work on in Burnsville.

Clear View runs both sides of the business out of the same shop. If you're booking a glass restoration in Burnsville, bundle pricing applies when we restore or coat another surface in the same visit.

Get a quote

Ready for a glass restoration install in Burnsville?

Tell us about your glass project in Burnsville. Photos help. We reply within one business day.

  • Free on-site measurement
  • 10-year written HydroShield warranty
  • No subcontractors, no upsells
FREE QUOTE

Tell us about your glass.

Text David (fastest) Call