Small (utility area)
Up to ~300 sq ft
From
$800
to $3,400
- Most common for mechanical rooms or storage areas
- Essential tier often the right pick
Basement Floor Coating · Long Lake, MN · Est. 1996
Basement Floor Coating in Long Lake, Minnesota.
Long Lake is a small city on Hwy 12 in western Hennepin County, north of Lake Minnetonka and wrapped around the lake it is named for. It is one of the few places out here with an actual walkable main street rather than a highway strip. Basement coating for Long Lake homes. We start with a moisture test, then match the system to what the slab can hold: penetrating sealer for high vapor pressure, polyurea + polyaspartic for normal-vapor slabs you want to look finished. A compact older core of early and mid-1900s homes on small lots, most with detached garages that were added later and built for smaller cars. Postwar and 1970s stock fills the rest of the city, and newer infill and rebuild work appears on the better lots near the water. Three-car attached garages are the exception rather than the rule, which makes Long Lake projects smaller on average than the surrounding acreage cities.
Basement Floor Coating in Long Lake
What an install looks like in Long Lake.
Long Lake is small-town rather than acreage, which sets it apart from Medina and Orono either side of it. Garages are modest and frequently detached, sitting on slabs that have been through six or seven decades, so the honest assessment of the concrete matters as much as the finish conversation. Where a slab is sound the change is dramatic, because the starting point is bare, dusty, never-finished floor. Lake-adjacent lots read higher for moisture and get tested before any lower-level work is quoted, while the higher ground toward Holy Name is straightforward.
Basement Floor Coating specifically in Long Lake
Moisture testing decides the system in Long Lake rather than confirming a default. Lake-adjacent slabs read higher and more often take a penetrating sealer that lets the slab breathe; higher ground toward Holy Name and Watertown Road usually tests normal and runs the film system. Older basements poured before vapor barriers were standard skew the readings up regardless of position.
Neighborhoods we work in
- Downtown Long Lake
- Lakeview
- Brown Road
- Watertown Road
- Holy Name
- Willow Drive
30+ YR
Years working concrete
Including chronic basement moisture
100%
Slabs moisture-tested
Before quoting, before installing
0
Subcontractors
David installs every job personally
A+
BBB rated
Accredited since October 2005
Why we moisture-test before quoting in Long Lake
Why basement floors fail (and how to avoid it).
Basement coatings fail at a much higher rate than garage coatings, and the reason is almost always the same: moisture. Without a vapor barrier under the slab, ground moisture migrates upward through the concrete and pushes against any film coating from below. Eventually that pressure wins, and the coating bubbles or lifts. The fix isn't a better coating; it's matching the system to the slab's moisture behavior.
Film coating on a vapor-prone slab
What you don't want
- Vapor pressure pushes from underneath
- Coating blisters, then peels in 12 to 36 months
- Often advertised as if moisture didn't matter
- Re-do cost is higher than the original
Matched system + moisture test
What we install
- Calcium chloride or RH test before quoting
- Breathable sealer for high-vapor slabs
- Film coating only on confirmed normal-vapor slabs
- Honest conversation if no coating is the right answer
If your basement slab is high-moisture and you want a finished look, the right path is moisture mitigation first, then coating. We'll say so if that's the case.
Long Lake Pricing
Basement floor coating pricing in Long Lake, MN.
Basement square footage tends to be larger than garages, so total project pricing scales. The moisture test result, the system tier, and the prep scope (existing paint or coating removal, crack repair) drive the final number. Quote is written and fixed.
Medium (partial basement)
~400 to 700 sq ft
From
$1,800
to $5,800
- Standard for finished playrooms and home gyms
- Tier choice depends on moisture test
Large (full basement)
800+ sq ft
From
$3,400
to $9,000+
- Full-floor finished basement installs
- Bundle pricing if combined with garage
Removing existing paint, coating, or carpet adhesive adds to prep time. If we find a moisture issue during the test, we'll either adjust the recommendation or walk you through your options before continuing.
The 6-step install
How we install your floor in Long Lake.
Moisture-aware prep is what separates a basement coating that lasts from one that lifts. Same checklist every job.
- 1
In-home assessment + moisture test
David visits the basement, runs a calcium chloride or RH moisture test, checks for existing coating, paint, or adhesive, then writes a fixed quote on the tier that matches what the slab can hold. - 2
Surface prep
Diamond grinding to open the concrete profile and remove any existing paint, sealer, or carpet adhesive. The prep depth depends on what's currently down; old paint takes longer than bare concrete. - 3
Crack and joint repair
Hairline cracks filled and tooled flat. Larger cracks or joint failures get addressed before the coating goes down so they don't telegraph through the finished floor. - 4
Sealer or basecoat application
Essential tier: penetrating sealer worked into the concrete. Advanced or Ultimate: full basecoat rolled and back-rolled. The chemistry depends on which tier matched the moisture test result. - 5
Decorative flake + topcoat (Ultimate tier)
On Ultimate-tier installs, decorative flake is broadcast into the wet basecoat, scraped flat after cure, and sealed under a polyaspartic topcoat. Essential tier is single-step and skips this stage. - 6
Walk-through + warranty packet
Final walk-through, written warranty document, care guide. Most basement coatings can be walked on in 24 hours; heavy furniture goes back in 72.
Long Lake questions
Common questions for Long Lake homeowners.
Is a 1950s detached garage in Long Lake worth coating?
Condition decides it, not age. Most older Long Lake garage slabs are dusty, pitted near the door and cracked through the joints, all of which diamond grinding and joint repair address. What rules a slab out is settlement, cracking well past hairline, or deep spalling. We assess in person and tell you which one you have before quoting, because putting a finished surface over a failing slab helps nobody.
The garage is unheated. Can you still install in winter?
Often, within limits. Polyurea and polyaspartic cure across a wider temperature range than epoxy, which is one reason Clear View uses them, so the window is broader than a hardware-store product would allow. Deep winter in an unheated detached garage still needs planning, and we would rather schedule into a workable window than promise a date and install outside product spec.
Does Hwy 12 salt reach the residential streets?
It reaches the properties along it and the first block or so back, and the wear at the garage door line shows it. Interior streets get far less. Where the exposure is real, a coating puts a chemically stable barrier between the salt and the concrete and stops the freeze-thaw-with-salt cycle that produces the pitting in the first place.
Our house is near the lake. Does that affect the basement floor?
It affects which system, which is why we test rather than assume. Lake-adjacent lots sit closer to groundwater and their slabs push more vapor. A film coating over a slab pushing vapor lifts off the floor eventually. High readings get a penetrating sealer that seals while letting the slab breathe; the higher ground toward Holy Name and Watertown Road usually tests normal and takes the film system.
Can you coat any basement floor?
Most basement slabs are coatable. The question is which system. If the moisture test comes back high, a film coating isn't the right answer; a breathable sealer is. We'll tell you which before quoting either way.
What's the moisture test you run?
A calcium chloride moisture vapor emission test or an in-situ RH probe, depending on the slab. Both measure how much water vapor is moving through the concrete. The number determines which coating chemistry can bond without lifting.
What if my basement floods occasionally?
That's a moisture management question first, coating question second. A coating won't fix a flooding problem; it'll just trap water against the slab. If flooding is a known issue, address that first, then come back to us for the finished floor.
Will a coating help with cold floors?
A coating doesn't add R-value. If cold floors are the issue, look at sub-slab insulation or a floating subfloor system. The coating goes on top of whatever flooring approach you choose.
Can I install carpet or vinyl over a coated floor?
Yes, polyurea-coated floors take overlay flooring well. Many homeowners coat for moisture protection first, then install carpet or LVP on top as the finished look.
How long does a basement install take?
Most basements are 1 to 2 days. Larger spaces or heavy prep can push to 3. We schedule with you so you can plan around utility room access.
Will it smell during the install?
Polyurea and polyaspartic have low odor compared to traditional epoxy. There's still some, especially during the basecoat hour. Open windows or run exhaust fans during the install if anyone in the home is sensitive.
Do you remove existing carpet, tile, or paint?
We can. Carpet removal is straightforward; old tile or thinset is more involved. Paint and old sealer come off during the diamond grind prep. Removal scope gets added to the quote.
Do you offer a warranty?
Yes. Written limited warranty on every install, terms vary by tier. David walks through warranty details during the in-home estimate.
More in Long Lake
All the services we offer in Long Lake, MN.
Garage, basement, patio, driveway. The same owner installs them all, often in the same visit. Bundle pricing if you're coating multiple surfaces.
Restoration in Long Lake
Other surfaces we work on in Long Lake.
Clear View runs both sides of the business out of the same shop. If you're booking a basement floor coating in Long Lake, bundle pricing applies when we restore or coat another surface in the same visit.
Basement Floor Coating elsewhere
Basement Floor Coating in nearby cities.
Same moisture-aware approach across the service area. If you're outside {city}, here's where else we work.
- Basement Floor Coating in Chaska, MN
- Basement Floor Coating in Chanhassen, MN
- Basement Floor Coating in Eden Prairie, MN
- Basement Floor Coating in Bloomington, MN
- Basement Floor Coating in Edina, MN
- Basement Floor Coating in Minnetonka, MN
- Basement Floor Coating in Shakopee, MN
- Basement Floor Coating in Prior Lake, MN
- Basement Floor Coating in Waconia, MN
- Basement Floor Coating in Victoria, MN
- Basement Floor Coating in Plymouth, MN
- Basement Floor Coating in Excelsior, MN
- Basement Floor Coating in Minnetrista, MN
Get a quote
Ready for a basement floor coating install in Long Lake?
Tell us about your basement and current floor. We'll get back to schedule the in-home moisture test and quote for Long Lake within one business day.
- Free on-site measurement
- Written limited warranty
- No subcontractors, no upsells