Single (1-car wide)
~400 to 600 sq ft
From
$1,200
to $6,800
- Most common single-vehicle drives
- Essential or Ultimate tier
Driveway Coating · St. Louis Park, MN · Est. 1996
Driveway Coating in St. Louis Park, Minnesota.
St. Louis Park is a first-ring Hennepin County suburb pressed directly against Minneapolis, split by Hwy 100 and Hwy 7. It is the most urban city in the Clear View service area, and its housing reflects that: dense, older, and built long before three-car garages were a thing. Driveway coating for St. Louis Park homes. We match the system to how the driveway is used: penetrating sealer for protection-only, polyurea + polyaspartic for a finished surface, flexible urethane for older slabs with movement. The great majority of St. Louis Park went up between 1940 and 1960, and it is the classic postwar pattern: Cape Cods, ramblers and small two-story homes on tight lots, with 1-car and small 2-car garages, a large share of them detached. Fern Hill, Browndale and Minikahda Vista hold the earlier and larger stock. Newer condo, townhome and mixed-use development is concentrated near The West End and the light rail corridor. Garage slabs here are routinely sixty to eighty years old.
Driveway Coating in St. Louis Park
What an install looks like in St. Louis Park.
St. Louis Park is dense, old and close in, which makes it a different kind of job from the outer suburbs. Garages are small, frequently detached and unheated, and the slabs have usually been through six or seven decades. The upside is that a postwar slab in decent condition takes a coating extremely well and the visual change is enormous, because the starting point is bare, dusty, sixty-year-old concrete. The other thing that shows up here is restoration volume out of proportion to garage volume: the kitchens and bathrooms in Fern Hill and Browndale have been renovated repeatedly, so there is a lot of stone and shower glass in the city that has never had professional service.
Driveway Coating specifically in St. Louis Park
Driveways here are short and narrow on tight postwar lots, so projects are modest and usually bundled with the garage. Apex flexible tier handles the seasonal slab movement and the first-ring salt load off Hwy 100 and Hwy 7, and on concrete this old it also evens out decades of patchy weathering.
Neighborhoods we work in
- Fern Hill
- Browndale
- Minikahda Vista
- Texa-Tonka
- Elmwood
- Westwood Hills
30+ YR
Years working concrete
Driveways included
Salt
Resistant
De-icer + brine tolerant
UV
Stable
Polyaspartic topcoat
A+
BBB rated
Accredited since October 2005
Why sealing is the highest-ROI driveway service in St. Louis Park
Why driveway sealer is the difference between a 20-year driveway and a 30-year one.
Untreated Minnesota driveway concrete absorbs water, salt, and brine all winter. Each freeze-thaw cycle pulls the surface paste apart from inside (spalling), and the surface scales over time. A penetrating sealer is the cheapest intervention with the highest return: it stops the absorption, which stops the freeze-thaw damage. Reapplied every 5 to 7 years, it can add a decade of useful life to the slab.
Untreated driveway concrete
What most driveways look like
- Absorbs water, brine, de-icer
- Surface scales and spalls over time
- Faster aging from freeze-thaw
- Full replacement at 20 to 25 years
Sealed every 5 to 7 years
What we'd put on our own driveway
- Penetrating sealer blocks moisture absorption
- Slows freeze-thaw scaling significantly
- Affordable: a few hundred to a few thousand per cycle
- Adds 10+ years to slab life
A sealer is not glamorous, but a $1,500 sealer cycle every 6 years is a much better deal than a $12,000 replacement at year 20.
St. Louis Park Pricing
Driveway coating pricing in St. Louis Park, MN.
Driveway pricing tracks square footage closely. The choice of tier and current slab condition do the rest. Most driveways are a 1- to 2-day install with a few days of cure before drive-on traffic.
Standard (2-car wide)
~700 to 1,000 sq ft
From
$2,400
to $10,000
- Typical suburban driveway with turnaround
- Most common is Essential sealer or Ultimate film
Large or oversize (3-car+ or extended)
1,200+ sq ft
From
$4,500
to $14,400+
- Long rural driveways, multi-car wide, or with parking areas
- Apex tier or premium sealer choice
Cracks, spalling, or oil-stained concrete add to prep time. We assess condition during the in-home estimate and write the quote to include any necessary repair work.
The 6-step install
How we install your floor in St. Louis Park.
Same prep on every driveway, scaled to the slab in front of us. The reason a 30-year coating shop stays busy is repeat customers from sealer cycles.
- 1
In-home assessment + written quote
Visit the property, measure the driveway, assess slab condition, write the fixed quote on the right tier. - 2
Surface clean + diamond-ground prep
Pressure wash to remove embedded dirt and stains, then diamond grinding for film-tier installs. Sealer-only tier skips the grind but still requires a thorough surface clean. - 3
Crack + spall repair
Hairline cracks filled. Spalled areas patched and feathered. Joints addressed before coating. - 4
Sealer or basecoat application
Essential tier: sealer worked into the concrete in two passes. Film tiers: polyurea or flexible urethane basecoat rolled at full thickness. - 5
Decorative + topcoat (film tiers)
Ultimate tier: decorative flake broadcast, scraped flat after cure, polyaspartic UV-stable topcoat seals everything in. Sealer tier skips this step. - 6
Walk-through + cure
Final walk-through. Walk-on at 24 hours for film tiers, 48 to 72 for sealer. Drive-on at 48 to 72 depending on tier and weather.
St. Louis Park questions
Common questions for St. Louis Park homeowners.
Is a 1950s St. Louis Park garage slab too old to coat?
Usually not. Age alone does not disqualify a slab; condition does. Most postwar St. Louis Park garage floors are dusty, pitted near the door and cracked through the joints, all of which are surface problems that diamond grinding and joint repair address. What rules a slab out is settlement, cracking well beyond hairline, or deep spalling. We assess in person and tell you honestly which one you have before quoting.
My garage is detached and unheated. Does that limit when you can install?
Less than you would think. Polyurea and polyaspartic cure across a wider temperature range than epoxy, which is one of the reasons Clear View uses them, so the install window is broader than it would be with a hardware-store product. Deep winter in an unheated detached garage still needs planning, and we work that out at the estimate rather than promising a date we cannot hold.
Do you work this far into the city?
Yes. St. Louis Park is nineteen miles from the Chaska shop, roughly twenty-six to thirty-four minutes via Hwy 212 and Hwy 62, and it is inside the standard service area with no travel adjustment. It is the most urban city on the regular calendar.
Can you restore a marble vanity from a 1990s renovation?
Yes, and it is common work in St. Louis Park, where the housing is old enough that most kitchens and bathrooms have been redone at least once. Marble from a 1990s renovation is now thirty years old and has usually taken years of ordinary cleaner, which etches the surface. Progressive polishing lifts the etched layer and rematches the original finish, then a fresh impregnating sealer protects it.
Will this stop my driveway from cracking?
No coating prevents future cracking; the slab moves with the seasons and that movement causes cracking over time. The Apex tier (flexible urethane) bridges existing hairline cracks so they don't telegraph through. Sealer prevents the surface scaling that comes from absorbed moisture freezing, which is different.
How often do I re-seal?
Essential sealer: every 5 to 7 years for Minnesota driveways. Film coatings (Ultimate, Apex) last much longer; on a typical install, no maintenance re-coat for 10+ years.
What about snow plowing and shovels?
Plastic shovels and rubber-edged plow blades are fine on either sealer or film. Metal-edge plows or sharp scrapers will eventually mark the topcoat surface; same as they would on stamped concrete. Daily ice melt use is fine.
Can you do it over an asphalt driveway?
No. These systems are concrete-specific. Asphalt sealers are a separate category and we don't offer them.
What about hot tire pickup?
Polyurea handles hot tires without lifting; this is the most common epoxy failure mode but not a polyurea problem.
How long does the install take?
Most driveways are 1 to 2 days on site. Drive-on cure is 48 hours minimum for film tiers, longer for sealer in cool weather. We schedule with you so you can plan around vehicle access.
Will it look glossy?
Essential sealer is matte (looks like wet concrete that's now dry). Ultimate and Apex tiers have a satin to semi-gloss topcoat finish; the exact level is chosen at the estimate.
Can I coat just part of the driveway?
Yes, sealer can be re-applied in sections. Film coatings work best as a single-day full install; partial film coating creates a visible seam.
Do you offer a warranty?
Yes, written limited warranty on every install, with terms varying by tier. Walked through at the estimate.
More in St. Louis Park
All the services we offer in St. Louis Park, MN.
Driveway plus garage plus walkway is a common multi-surface visit. Bundle pricing when we can prep multiple slabs in the same install window.
Restoration in St. Louis Park
Other surfaces we work on in St. Louis Park.
Clear View runs both sides of the business out of the same shop. If you're booking a driveway coating in St. Louis Park, bundle pricing applies when we restore or coat another surface in the same visit.
Driveway Coating elsewhere
Driveway Coating in nearby cities.
Same system options across the metro. If you're outside {city}, here's where else we work.
- Driveway Coating in Chaska, MN
- Driveway Coating in Chanhassen, MN
- Driveway Coating in Eden Prairie, MN
- Driveway Coating in Bloomington, MN
- Driveway Coating in Edina, MN
- Driveway Coating in Minnetonka, MN
- Driveway Coating in Shakopee, MN
- Driveway Coating in Prior Lake, MN
- Driveway Coating in Waconia, MN
- Driveway Coating in Victoria, MN
- Driveway Coating in Plymouth, MN
- Driveway Coating in Excelsior, MN
- Driveway Coating in Minnetrista, MN
Get a quote
Ready for a driveway coating install in St. Louis Park?
Tell us about your driveway. We'll get back with quote details for St. Louis Park within one business day.
- Free on-site measurement
- Written limited warranty
- No subcontractors, no upsells