Small (small inground or above-ground surround)
Up to ~300 sq ft
From
$1,800
to $5,800
- Above-ground pool decks and small inground surrounds
- Ultimate tier standard
Pool Deck Coating · St. Louis Park, MN · Est. 1996
Pool Deck Coating in St. Louis Park, Minnesota.
St. Louis Park is a first-ring Hennepin County suburb pressed directly against Minneapolis, split by Hwy 100 and Hwy 7. It is the most urban city in the Clear View service area, and its housing reflects that: dense, older, and built long before three-car garages were a thing. Pool deck coating for St. Louis Park homes. Aggregate-textured polyaspartic topcoats for wet-surface grip, light color options to reduce heat absorption, full prep including any chlorinated-area concrete damage. The great majority of St. Louis Park went up between 1940 and 1960, and it is the classic postwar pattern: Cape Cods, ramblers and small two-story homes on tight lots, with 1-car and small 2-car garages, a large share of them detached. Fern Hill, Browndale and Minikahda Vista hold the earlier and larger stock. Newer condo, townhome and mixed-use development is concentrated near The West End and the light rail corridor. Garage slabs here are routinely sixty to eighty years old.
Pool Deck Coating in St. Louis Park
What an install looks like in St. Louis Park.
St. Louis Park is dense, old and close in, which makes it a different kind of job from the outer suburbs. Garages are small, frequently detached and unheated, and the slabs have usually been through six or seven decades. The upside is that a postwar slab in decent condition takes a coating extremely well and the visual change is enormous, because the starting point is bare, dusty, sixty-year-old concrete. The other thing that shows up here is restoration volume out of proportion to garage volume: the kitchens and bathrooms in Fern Hill and Browndale have been renovated repeatedly, so there is a lot of stone and shower glass in the city that has never had professional service.
Pool Deck Coating specifically in St. Louis Park
In-ground pools are uncommon in St. Louis Park given the lot sizes, so pool deck work is occasional. Where one exists, the Apex tier applies as elsewhere: slip-resistant aggregate broadcast, chlorine-tolerant, UV-stable, cooler underfoot than bare concrete in July. Installs schedule May through early September.
Neighborhoods we work in
- Fern Hill
- Browndale
- Minikahda Vista
- Texa-Tonka
- Elmwood
- Westwood Hills
Slip
Resistant
Aggregate added to topcoat
UV
Stable
Polyaspartic topcoat
Cl
Tolerant
Chlorinated water + salt OK
A+
BBB rated
Accredited since October 2005
Why pool decks need their own spec in St. Louis Park
What makes a pool deck coating different from a patio coating.
Three things: slip resistance, heat reflectivity, and chemical exposure. A pool deck coating without all three is a patio coating in the wrong context. Aggregate in the topcoat handles grip. Light color reflects heat for barefoot comfort. UV-stable, chlorine-tolerant chemistry handles the chemical side. We don't shortcut any of the three.
St. Louis Park Pricing
Pool deck coating pricing in St. Louis Park, MN.
Pool deck pricing tracks square footage and prep complexity. Concrete near pools sometimes has settling, efflorescence from chlorinated water, or surface damage from years of pool chemicals; all that gets addressed during prep.
Standard (inground residential)
~400 to 700 sq ft
From
$3,400
to $9,000
- Most residential inground pool decks
- Ultimate with grip aggregate is the standard pick
Large or premium
800+ sq ft
From
$5,000
to $14,400+
- Large pool surrounds, outdoor entertainment areas
- Apex for older slabs with cracking
Pool deck installs schedule around the pool-open season. We can install over the spring opening window or in fall after closing; both work better than mid-summer for cure conditions.
The 6-step install
How we install your floor in St. Louis Park.
Pool deck prep is more involved than a normal patio because of the water exposure history. Same checklist, scaled to the conditions.
- 1
On-site assessment + written quote
Visit, measure the deck, evaluate existing condition including any chlorine-exposure damage, write a fixed quote. - 2
Cover the pool + protect surrounding plantings
Pool surface covered to keep prep dust and coating material out. Plantings and any features near the deck masked or covered. - 3
Diamond-ground prep + crack repair
Full surface prep, crack filling, edge repair near the pool waterline if needed. - 4
Basecoat application
Polyurea or flexible urethane basecoat depending on tier, rolled and back-rolled. - 5
Decorative flake + aggregate topcoat
Decorative flake broadcast into wet basecoat. After cure, scraped flat. Polyaspartic topcoat with grip aggregate broadcast in for slip resistance. - 6
Walk-through + cure
Final walk-through. Walkable in 24 hours, fully cured for swim use in 48.
St. Louis Park questions
Common questions for St. Louis Park homeowners.
Is a 1950s St. Louis Park garage slab too old to coat?
Usually not. Age alone does not disqualify a slab; condition does. Most postwar St. Louis Park garage floors are dusty, pitted near the door and cracked through the joints, all of which are surface problems that diamond grinding and joint repair address. What rules a slab out is settlement, cracking well beyond hairline, or deep spalling. We assess in person and tell you honestly which one you have before quoting.
My garage is detached and unheated. Does that limit when you can install?
Less than you would think. Polyurea and polyaspartic cure across a wider temperature range than epoxy, which is one of the reasons Clear View uses them, so the install window is broader than it would be with a hardware-store product. Deep winter in an unheated detached garage still needs planning, and we work that out at the estimate rather than promising a date we cannot hold.
Do you work this far into the city?
Yes. St. Louis Park is nineteen miles from the Chaska shop, roughly twenty-six to thirty-four minutes via Hwy 212 and Hwy 62, and it is inside the standard service area with no travel adjustment. It is the most urban city on the regular calendar.
Can you restore a marble vanity from a 1990s renovation?
Yes, and it is common work in St. Louis Park, where the housing is old enough that most kitchens and bathrooms have been redone at least once. Marble from a 1990s renovation is now thirty years old and has usually taken years of ordinary cleaner, which etches the surface. Progressive polishing lifts the etched layer and rematches the original finish, then a fresh impregnating sealer protects it.
Will it actually be slip resistant when wet?
Yes. The polyaspartic topcoat is broadcast with grip aggregate (fine silica or polymer beads, depending on the texture level you want) that gives bare feet traction on a wet surface. Aggressive enough for safety, fine enough not to be uncomfortable.
Will it get hot in the sun?
Light color choices reflect significantly more heat than dark ones. We recommend lighter flake blends for pool decks specifically for this reason. Not as cool as some specialty acrylic pool deck coatings, but far cooler than dark stained concrete.
Does chlorine damage the coating?
Polyaspartic is chlorine tolerant at normal pool concentrations. Saltwater pool systems are also fine. Heavy chemical spills (concentrated shock, muriatic acid) should still be rinsed off promptly, same as you would for any finished surface.
What about the pool coping or waterline edge?
We coat the horizontal deck surface. The vertical pool coping (stone or concrete cap at the waterline) is a separate decision; we can talk through whether to include it during the estimate.
Can I coat a concrete deck with a stamped pattern?
Film coatings cover stamped patterns. If you want to keep the decorative pattern, the Essential sealer (also offered) preserves the look while adding chlorine and freeze-thaw protection.
How long does the install take?
Most residential pool decks are 1 to 2 days on site. Larger or premium decks take longer. We coordinate around the pool-use season; spring or fall installs are easier than mid-summer.
When can I open the pool after the install?
48 hours for walk and swim use. Full coating cure continues for a week beyond that, but the surface is functionally ready at 48.
Do you offer a warranty?
Yes. Written limited warranty, terms vary by tier, walked through during the estimate.
More in St. Louis Park
All the services we offer in St. Louis Park, MN.
Pool deck plus surrounding patio is a common combined install. Same prep and chemistry; we can size the visit to do both.
Restoration in St. Louis Park
Other surfaces we work on in St. Louis Park.
Clear View runs both sides of the business out of the same shop. If you're booking a pool deck coating in St. Louis Park, bundle pricing applies when we restore or coat another surface in the same visit.
Pool Deck Coating elsewhere
Pool Deck Coating in nearby cities.
Same UV + chlorine-tolerant systems across the metro. If you're outside {city}, here's where else we work.
- Pool Deck Coating in Chaska, MN
- Pool Deck Coating in Chanhassen, MN
- Pool Deck Coating in Eden Prairie, MN
- Pool Deck Coating in Bloomington, MN
- Pool Deck Coating in Edina, MN
- Pool Deck Coating in Minnetonka, MN
- Pool Deck Coating in Shakopee, MN
- Pool Deck Coating in Prior Lake, MN
- Pool Deck Coating in Waconia, MN
- Pool Deck Coating in Victoria, MN
- Pool Deck Coating in Plymouth, MN
- Pool Deck Coating in Excelsior, MN
- Pool Deck Coating in Minnetrista, MN
Get a quote
Ready for a pool deck coating install in St. Louis Park?
Tell us about your pool deck. We'll get back with quote details for St. Louis Park within one business day.
- Free on-site measurement
- Written limited warranty
- No subcontractors, no upsells