Small (1-car or partial)
Up to ~250 sq ft
From
$800
to $3,400
- Most common for 1-car garages, shop bays, utility rooms
- Tier choice drives the price within this range
Garage Floor Coating · Richfield, MN · Est. 1996
Garage Floor Coating in Richfield, Minnesota.
Richfield is a first-ring suburb pinned between Minneapolis, Bloomington and the airport, laid out on a tight grid across roughly seven square miles. It was built almost entirely in one burst after the Second World War and has the most uniform housing stock in the service area. We coat garage floors for Richfield homeowners using Valence Protective Coatings systems: polyurea + polyaspartic on the long-life tiers, full diamond-ground prep on every job, written limited warranty in your hands at completion. Richfield is the classic postwar suburb: small ramblers and Cape Cods on modest lots, the overwhelming majority built between 1946 and 1958. Garages are usually 1-car or small 2-car and detached, sitting at the back of the lot off an alley or a side drive. Attached three-car garages barely exist here. A steady stream of teardown rebuilds and second-story additions has been changing individual houses for twenty years, so a brand-new build occasionally sits between two originals.
Garage Floor Coating in Richfield
What an install looks like in Richfield.
Richfield is a city of small detached garages that are all roughly the same age, which makes the work here unusually predictable and unusually prep-heavy. A seventy-year-old slab at the back of a Richfield lot has been through everything, and the honest assessment matters more than the sales pitch: some of these floors want a concrete contractor before they want a coating. Where the slab is sound, the change is dramatic, because the starting point is bare, dusty, alley-facing concrete. The teardown rebuilds are the other half of the picture, arriving with clean modern slabs and homeowners who want the garage finished before the first winter.
Garage Floor Coating specifically in Richfield
Richfield garage work is small-floor, prep-heavy and remarkably consistent, because the city was built in one postwar burst. Most projects are 1-car or small 2-car detached garages on slabs approaching seventy years old, with heavy dusting, door-line pitting and joint cracking. Diamond grinding, joint and pit repair, then polyurea basecoat and polyaspartic topcoat. Slabs that have settled get an honest recommendation for concrete work first. Teardown rebuilds are the opposite case and take minimal prep.
Neighborhoods we work in
- East Richfield
- West Richfield
- Central Richfield
- Woodlake
- Assumption
- Lyndale
30+ YR
Years restoring surfaces
Concrete, stone, glass since 1996
4
System tiers
Essential, Advanced, Ultimate, Apex
0
Subcontractors
David installs every job personally
A+
BBB rated
Accredited since October 2005
Why we don't lead with epoxy in Richfield
Why polyurea outlasts epoxy in a Minnesota garage.
Epoxy was the default for a long time. It's also the most common reason coatings fail in Minnesota: it yellows in sunlight, hot-tire pickup peels it off, and the freeze-thaw cycle finds every weak edge. Polyurea solves all three. It's flexible enough to ride out slab movement, UV-stable so it doesn't yellow, and bonded to the slab through diamond grinding so it doesn't lift.
Epoxy
What most cheap garage coatings still use
- Yellows in sunlight within 1 to 2 years
- Hot-tire pickup lifts the film off the slab
- Rigid film cracks with slab movement
- Slow cure: 5 to 7 days before driving
- Often applied over poor prep (acid etch instead of grinding)
Polyurea + polyaspartic
What Clear View installs on the Ultimate tier
- UV stable: the topcoat does not yellow
- Flexible enough to handle hot tires
- Diamond-ground bond: mechanical, not chemical
- Walk-on 24h, drive-on 48h
- Same flake color options as epoxy, longer life
Both systems still get installed across the Twin Cities. The price difference is real. The lifespan difference is bigger.
Richfield Pricing
Garage floor coating pricing in Richfield, MN.
Final price is a function of the slab (square footage, condition, joints, cracks), the tier you pick, and any prep work the concrete needs before the coating goes down. The ranges below are project totals from real installs, not per-square-foot teasers. Every quote is written and stable: the number we hand you at the estimate is the number you pay.
Standard (2-car)
~400 to 500 sq ft
From
$1,800
to $6,800
- Most installs land here
- Ultimate tier is the most common pick for 2-car garages
Large (3-car or oversized)
600+ sq ft
From
$3,200
to $14,400+
- Tier and prep dictate the upper end
- Apex tier on a 4-car floor with crack repair sits at the top of the range
Cracks, spalling, oil-stained concrete, or moisture issues add to the prep scope. We test for moisture and assess existing damage during the estimate so nothing surprises either of us later.
The 6-step install
How we install your floor in Richfield.
Same checklist on every install. The reason a 30-year-old shop stays in business is the work holding up at year ten.
- 1
In-home assessment + written quote
David visits the property, measures the slab, checks for moisture and existing damage, and writes a fixed quote on the tier that fits. No salesperson, no follow-up call campaigns, no contract pressure. The quote stays valid for 60 days. - 2
Diamond-ground prep
Day one starts with diamond grinding the entire slab to open the concrete profile. This is where most installers cut corners; we don't. The coating bond is only as good as the prep underneath it. - 3
Crack and joint repair
Any cracks, spalls, or joint failures get filled and tooled flat before the basecoat goes down. On older slabs this is the difference between a coating that lasts a decade and one that fails at year three. - 4
Basecoat application
Polyurea (Ultimate tier) or industrial urethane (Advanced tier) goes down at full mil thickness, rolled and back-rolled for even coverage. This is the structural layer that bonds to the prepped concrete. - 5
Decorative flake + sealing topcoat
On Ultimate-tier installs, full decorative flake is broadcast into the wet basecoat in your custom color blend. After cure, the excess is scraped, the floor swept, and the polyaspartic topcoat seals the system. - 6
Walk-through + warranty packet
Final walk-through with David on the finished floor, written warranty document in your hands, care guide for the first 30 days. Walk on at 24 hours, drive on at 48.
Richfield questions
Common questions for Richfield homeowners.
My Richfield garage is detached, off the alley, and from 1952. Is it worth coating?
It depends on the concrete, and that is a real answer rather than a hedge. Seventy-year-old slabs vary enormously: some are sound under a layer of dust and surface pitting, some have settled or cracked past the point where a coating is the right spend. We assess in person before quoting. Where the slab is good, diamond grinding and a polyurea system produce one of the most dramatic results we do, because nobody has ever finished that floor.
Do you work on single-stall garages?
Yes, and in Richfield they are the norm rather than the exception. The thing a small floor changes is the economics, since setup and mobilization do not shrink with the square footage. Scheduling alongside a neighbor makes both projects more efficient, and on Richfield's tight blocks that comes up more often than you would expect.
Is Richfield within your service area? It is closer to Minneapolis than to Chaska.
It is on the eastern edge and it is inside the area. Twenty-two miles, roughly twenty-eight to thirty-six minutes via Hwy 212 and Hwy 62, with no travel adjustment in the quote. Past Richfield the answer becomes case-by-case rather than routine.
We just did a teardown rebuild. Should we coat the new garage floor now or wait?
Now, comfortably. A slab that has never seen road salt or a hot tire needs no grinding of old coating and no pit repair, so prep is minimal and the finished surface is as good as the system can produce. Coating before the first winter means the concrete never takes the damage in the first place. New-construction floors are among the least expensive projects we quote.
How long will a polyurea garage floor coating last?
On the Ultimate or Apex tier, with full prep and routine cleaning, 15 to 20+ years is realistic. Most failures we see in other installs trace back to skipped prep, not the coating itself. The film is durable; the bond underneath it is what determines lifespan.
What's the install timeline?
Most 2-car garages are a 1-day install. Larger spaces, heavy crack repair, or full-color custom builds run into a second day. We schedule the install so you can walk on the floor within 24 hours of completion and drive on it within 48.
Do you actually do the work yourself?
Yes. David handles every install personally; no subcontractors, no rotating crew. If you have a question during the job, you ask David. That's the entire reason it's owner-operated.
What about hot-tire pickup?
Polyurea is flexible enough to handle hot tires without lifting. This is one of the most common epoxy failure modes; it's not a polyurea problem. Park hot tires on a polyurea floor for a decade and the film stays bonded.
Will the topcoat yellow in sunlight?
Polyaspartic is UV stable. The topcoat does not yellow or chalk. This is true for garages with windows, three-season rooms, and any installation that sees direct sun.
Do I need to clear out the garage before you start?
Yes. The floor needs to be completely empty of cars, storage, shelving contents, and tools. Permanently mounted items (water heater, furnace, support posts, wall-mounted shelving) we work around. Plan to clear the day before; it always takes longer than people expect.
What if my slab has existing cracks?
Fine hairline cracks are normal and filled during prep. Active cracks or significant spalling get evaluated during the estimate; either we repair them as part of the install (added to the quote) or, if the slab needs more substantial repair, we say so honestly before the job starts.
Do you offer a warranty?
Yes, every install includes a written limited warranty document. Specific terms vary by tier; David walks through the warranty during the in-home estimate so you know exactly what's covered before you sign.
What time of year is best for an install?
Polyurea cures in a wide temperature range, so installs run year-round in heated garages. Unheated spaces are easier April through October. We schedule installs ahead during peak season (May to September) by 3 to 6 weeks.
Is this a franchise or a local business?
Independent, locally owned, owner-operated. Clear View Surface Solutions has been a Chaska, MN business since 1996. BBB accredited A+ since October 2005. Not a national franchise.
More in Richfield
All the services we offer in Richfield, MN.
Whatever the slab (garage, basement, patio, driveway, pool deck), the same tier system applies and the same person installs it. Bundle pricing if you're coating multiple surfaces in one visit.
Restoration in Richfield
Other surfaces we work on in Richfield.
Clear View runs both sides of the business out of the same shop. If you're booking a garage floor coating in Richfield, bundle pricing applies when we restore or coat another surface in the same visit.
Garage Floor Coating elsewhere
Garage Floor Coating in nearby cities.
Same tier system, same owner-operated install, same written warranty across the service area. If you're outside {city}, here's where else we work.
- Garage Floor Coating in Chaska, MN
- Garage Floor Coating in Chanhassen, MN
- Garage Floor Coating in Eden Prairie, MN
- Garage Floor Coating in Bloomington, MN
- Garage Floor Coating in Edina, MN
- Garage Floor Coating in Minnetonka, MN
- Garage Floor Coating in Shakopee, MN
- Garage Floor Coating in Prior Lake, MN
- Garage Floor Coating in Waconia, MN
- Garage Floor Coating in Victoria, MN
- Garage Floor Coating in Plymouth, MN
- Garage Floor Coating in Excelsior, MN
- Garage Floor Coating in Minnetrista, MN
Get a quote
Ready for a garage floor coating install in Richfield?
Send four photos of your garage slab or fill out the form below. We'll text or email back a real quote for Richfield within one business day.
- Free on-site measurement
- Written limited warranty
- No subcontractors, no upsells