Small (1-car or partial)
Up to ~250 sq ft
From
$800
to $3,400
- Most common for 1-car garages, shop bays, utility rooms
- Tier choice drives the price within this range
Garage Floor Coating · Mound, MN · Est. 1996
Garage Floor Coating in Mound, Minnesota.
Mound wraps around the western bays of Lake Minnetonka, and the shoreline defines the city. Streets follow the water rather than a grid, lots are irregular, and a large share of the housing began life as seasonal lake property before being converted to year-round homes. We coat garage floors for Mound homeowners using Valence Protective Coatings systems: polyurea + polyaspartic on the long-life tiers, full diamond-ground prep on every job, written limited warranty in your hands at completion. Mound has the most unusual housing profile in the service area. Much of Island Park, Three Points and the older shoreline was built as 1920s through 1950s summer cottages and converted to year-round use later, which means garages that were added decades after the house, frequently detached, often unheated and sometimes on slabs poured directly on lake-adjacent ground. Shirley Hills and Highland hold more conventional postwar and 1970s stock. Teardown-and-rebuild has been steady on the waterfront for twenty years, so brand-new construction sits next to converted cottages on the same block.
Garage Floor Coating in Mound
What an install looks like in Mound.
Mound is a moisture city. Being wrapped around Lake Minnetonka's western bays means a lot of slabs sit close to groundwater, and that single fact drives more of the technical conversation here than anywhere else Clear View works. Basement floors get a moisture reading before anything is quoted, and a meaningful share of them come back high enough that a film coating is the wrong answer. The garages tell the other half of the story: converted cottages with detached, unheated garages added long after the house, on slabs of unknown vintage and quality. Then on the same street there will be a 2015 teardown rebuild with a clean three-car slab. Both are normal bookings; they just need different answers.
Garage Floor Coating specifically in Mound
Mound garages come in two forms and the difference is decades. Converted-cottage properties in Island Park and Three Points typically have detached, unheated garages added long after the house, on slabs of unknown vintage that need assessment for settlement and moisture before a quote makes sense. Waterfront teardown rebuilds have clean modern three-car slabs where prep is minimal. The polyurea and polyaspartic system suits both, and it tolerates the temperature swing of an unheated detached garage better than epoxy does.
Neighborhoods we work in
- Island Park
- Three Points
- Shirley Hills
- Highland
- Seton
- Dutch Lake
30+ YR
Years restoring surfaces
Concrete, stone, glass since 1996
4
System tiers
Essential, Advanced, Ultimate, Apex
0
Subcontractors
David installs every job personally
A+
BBB rated
Accredited since October 2005
Why we don't lead with epoxy in Mound
Why polyurea outlasts epoxy in a Minnesota garage.
Epoxy was the default for a long time. It's also the most common reason coatings fail in Minnesota: it yellows in sunlight, hot-tire pickup peels it off, and the freeze-thaw cycle finds every weak edge. Polyurea solves all three. It's flexible enough to ride out slab movement, UV-stable so it doesn't yellow, and bonded to the slab through diamond grinding so it doesn't lift.
Epoxy
What most cheap garage coatings still use
- Yellows in sunlight within 1 to 2 years
- Hot-tire pickup lifts the film off the slab
- Rigid film cracks with slab movement
- Slow cure: 5 to 7 days before driving
- Often applied over poor prep (acid etch instead of grinding)
Polyurea + polyaspartic
What Clear View installs on the Ultimate tier
- UV stable: the topcoat does not yellow
- Flexible enough to handle hot tires
- Diamond-ground bond: mechanical, not chemical
- Walk-on 24h, drive-on 48h
- Same flake color options as epoxy, longer life
Both systems still get installed across the Twin Cities. The price difference is real. The lifespan difference is bigger.
Mound Pricing
Garage floor coating pricing in Mound, MN.
Final price is a function of the slab (square footage, condition, joints, cracks), the tier you pick, and any prep work the concrete needs before the coating goes down. The ranges below are project totals from real installs, not per-square-foot teasers. Every quote is written and stable: the number we hand you at the estimate is the number you pay.
Standard (2-car)
~400 to 500 sq ft
From
$1,800
to $6,800
- Most installs land here
- Ultimate tier is the most common pick for 2-car garages
Large (3-car or oversized)
600+ sq ft
From
$3,200
to $14,400+
- Tier and prep dictate the upper end
- Apex tier on a 4-car floor with crack repair sits at the top of the range
Cracks, spalling, oil-stained concrete, or moisture issues add to the prep scope. We test for moisture and assess existing damage during the estimate so nothing surprises either of us later.
The 6-step install
How we install your floor in Mound.
Same checklist on every install. The reason a 30-year-old shop stays in business is the work holding up at year ten.
- 1
In-home assessment + written quote
David visits the property, measures the slab, checks for moisture and existing damage, and writes a fixed quote on the tier that fits. No salesperson, no follow-up call campaigns, no contract pressure. The quote stays valid for 60 days. - 2
Diamond-ground prep
Day one starts with diamond grinding the entire slab to open the concrete profile. This is where most installers cut corners; we don't. The coating bond is only as good as the prep underneath it. - 3
Crack and joint repair
Any cracks, spalls, or joint failures get filled and tooled flat before the basecoat goes down. On older slabs this is the difference between a coating that lasts a decade and one that fails at year three. - 4
Basecoat application
Polyurea (Ultimate tier) or industrial urethane (Advanced tier) goes down at full mil thickness, rolled and back-rolled for even coverage. This is the structural layer that bonds to the prepped concrete. - 5
Decorative flake + sealing topcoat
On Ultimate-tier installs, full decorative flake is broadcast into the wet basecoat in your custom color blend. After cure, the excess is scraped, the floor swept, and the polyaspartic topcoat seals the system. - 6
Walk-through + warranty packet
Final walk-through with David on the finished floor, written warranty document in your hands, care guide for the first 30 days. Walk on at 24 hours, drive on at 48.
Mound questions
Common questions for Mound homeowners.
My Mound house is close to the lake. Can the basement floor be coated?
Maybe, and the moisture reading decides it rather than the address. Slabs near the Lake Minnetonka shoreline sit close to groundwater and push more vapor than an upland slab. A film coating over a slab pushing vapor will lift off the floor over time, which is a failure we would rather prevent than warranty. High readings get a penetrating sealer that seals the concrete while letting it breathe. We test before quoting, every time, in this city especially.
The garage was added to the cottage in the 1960s. Is that slab coatable?
Often yes, once we have seen it. Garages added to converted lake cottages were built to whatever standard applied at the time, sometimes on ground that has since moved, and there is rarely any record. We check for settlement, deep cracking and moisture before quoting. Sound slabs coat well. Slabs that have moved get an honest recommendation for concrete work first.
Can you coat an unheated detached garage in Mound in the winter?
Sometimes, and it depends on the week. Polyurea and polyaspartic cure across a wider temperature range than epoxy, which widens the window considerably, but an unheated detached garage in deep winter still has limits. We would rather schedule it into a workable window than promise a date and install outside product spec. Off-peak scheduling from November through March is usually easier to get regardless.
Do you drive out around the lake for a single project?
Yes. Mound is eighteen miles from Chaska, roughly twenty-eight to thirty-four minutes around the lake on Hwy 7, and it is inside the standard service area with no travel adjustment in the quote. The drive around Lake Minnetonka is longer than the straight-line distance suggests, which is worth knowing when you are comparing scheduling windows.
How long will a polyurea garage floor coating last?
On the Ultimate or Apex tier, with full prep and routine cleaning, 15 to 20+ years is realistic. Most failures we see in other installs trace back to skipped prep, not the coating itself. The film is durable; the bond underneath it is what determines lifespan.
What's the install timeline?
Most 2-car garages are a 1-day install. Larger spaces, heavy crack repair, or full-color custom builds run into a second day. We schedule the install so you can walk on the floor within 24 hours of completion and drive on it within 48.
Do you actually do the work yourself?
Yes. David handles every install personally; no subcontractors, no rotating crew. If you have a question during the job, you ask David. That's the entire reason it's owner-operated.
What about hot-tire pickup?
Polyurea is flexible enough to handle hot tires without lifting. This is one of the most common epoxy failure modes; it's not a polyurea problem. Park hot tires on a polyurea floor for a decade and the film stays bonded.
Will the topcoat yellow in sunlight?
Polyaspartic is UV stable. The topcoat does not yellow or chalk. This is true for garages with windows, three-season rooms, and any installation that sees direct sun.
Do I need to clear out the garage before you start?
Yes. The floor needs to be completely empty of cars, storage, shelving contents, and tools. Permanently mounted items (water heater, furnace, support posts, wall-mounted shelving) we work around. Plan to clear the day before; it always takes longer than people expect.
What if my slab has existing cracks?
Fine hairline cracks are normal and filled during prep. Active cracks or significant spalling get evaluated during the estimate; either we repair them as part of the install (added to the quote) or, if the slab needs more substantial repair, we say so honestly before the job starts.
Do you offer a warranty?
Yes, every install includes a written limited warranty document. Specific terms vary by tier; David walks through the warranty during the in-home estimate so you know exactly what's covered before you sign.
What time of year is best for an install?
Polyurea cures in a wide temperature range, so installs run year-round in heated garages. Unheated spaces are easier April through October. We schedule installs ahead during peak season (May to September) by 3 to 6 weeks.
Is this a franchise or a local business?
Independent, locally owned, owner-operated. Clear View Surface Solutions has been a Chaska, MN business since 1996. BBB accredited A+ since October 2005. Not a national franchise.
More in Mound
All the services we offer in Mound, MN.
Whatever the slab (garage, basement, patio, driveway, pool deck), the same tier system applies and the same person installs it. Bundle pricing if you're coating multiple surfaces in one visit.
Restoration in Mound
Other surfaces we work on in Mound.
Clear View runs both sides of the business out of the same shop. If you're booking a garage floor coating in Mound, bundle pricing applies when we restore or coat another surface in the same visit.
Garage Floor Coating elsewhere
Garage Floor Coating in nearby cities.
Same tier system, same owner-operated install, same written warranty across the service area. If you're outside {city}, here's where else we work.
- Garage Floor Coating in Chaska, MN
- Garage Floor Coating in Chanhassen, MN
- Garage Floor Coating in Eden Prairie, MN
- Garage Floor Coating in Bloomington, MN
- Garage Floor Coating in Edina, MN
- Garage Floor Coating in Minnetonka, MN
- Garage Floor Coating in Shakopee, MN
- Garage Floor Coating in Prior Lake, MN
- Garage Floor Coating in Waconia, MN
- Garage Floor Coating in Victoria, MN
- Garage Floor Coating in Plymouth, MN
- Garage Floor Coating in Excelsior, MN
- Garage Floor Coating in Minnetrista, MN
Get a quote
Ready for a garage floor coating install in Mound?
Send four photos of your garage slab or fill out the form below. We'll text or email back a real quote for Mound within one business day.
- Free on-site measurement
- Written limited warranty
- No subcontractors, no upsells