Small (small inground or above-ground surround)
Up to ~300 sq ft
From
$1,800
to $5,800
- Above-ground pool decks and small inground surrounds
- Ultimate tier standard
Pool Deck Coating · Jordan, MN · Est. 1996
Pool Deck Coating in Jordan, Minnesota.
Jordan sits in the Minnesota River valley in Scott County, where Sand Creek cuts down through the bluffs to meet the river. The old town is on the valley floor and the newer subdivisions climb the bluff above it, which gives the city an unusual amount of elevation change for its size. Pool deck coating for Jordan homes. Aggregate-textured polyaspartic topcoats for wet-surface grip, light color options to reduce heat absorption, full prep including any chlorinated-area concrete damage. Jordan's historic core holds late-1800s and early-1900s homes, many with detached garages added much later on slabs of uncertain vintage. The bluff-top subdivisions are a different era entirely: 1990s through 2010s construction with 3-car attached garages and full basements. The elevation difference between the two is the practical story, because a valley-floor basement and a bluff-top basement are not the same job.
Pool Deck Coating in Jordan
What an install looks like in Jordan.
Jordan is a small city with two very different sets of houses, and the bluff is the dividing line. Down on the valley floor the homes are old, the garages are usually detached and added later, and the ground holds water, so a Jordan basement estimate on the flat is a moisture conversation before it is anything else. Up on the bluff the subdivisions are newer, the garages are attached and three-car, the lots drain, and the work looks like any other newer suburb. Both are twenty minutes down Hwy 169 from the Chaska shop, which makes Jordan one of the easier outer cities to schedule.
Pool Deck Coating specifically in Jordan
In-ground pools in Jordan are uncommon and almost entirely on the larger bluff-top lots. Apex tier with slip-resistant aggregate broadcast, chlorine-tolerant, UV-stable, and cooler underfoot than bare concrete in July. Installs schedule May through early September.
Neighborhoods we work in
- Downtown Jordan
- Bluff Country
- Timber Ridge
- Sand Creek
- Valley View
- Hillside
Slip
Resistant
Aggregate added to topcoat
UV
Stable
Polyaspartic topcoat
Cl
Tolerant
Chlorinated water + salt OK
A+
BBB rated
Accredited since October 2005
Why pool decks need their own spec in Jordan
What makes a pool deck coating different from a patio coating.
Three things: slip resistance, heat reflectivity, and chemical exposure. A pool deck coating without all three is a patio coating in the wrong context. Aggregate in the topcoat handles grip. Light color reflects heat for barefoot comfort. UV-stable, chlorine-tolerant chemistry handles the chemical side. We don't shortcut any of the three.
Jordan Pricing
Pool deck coating pricing in Jordan, MN.
Pool deck pricing tracks square footage and prep complexity. Concrete near pools sometimes has settling, efflorescence from chlorinated water, or surface damage from years of pool chemicals; all that gets addressed during prep.
Standard (inground residential)
~400 to 700 sq ft
From
$3,400
to $9,000
- Most residential inground pool decks
- Ultimate with grip aggregate is the standard pick
Large or premium
800+ sq ft
From
$5,000
to $14,400+
- Large pool surrounds, outdoor entertainment areas
- Apex for older slabs with cracking
Pool deck installs schedule around the pool-open season. We can install over the spring opening window or in fall after closing; both work better than mid-summer for cure conditions.
The 6-step install
How we install your floor in Jordan.
Pool deck prep is more involved than a normal patio because of the water exposure history. Same checklist, scaled to the conditions.
- 1
On-site assessment + written quote
Visit, measure the deck, evaluate existing condition including any chlorine-exposure damage, write a fixed quote. - 2
Cover the pool + protect surrounding plantings
Pool surface covered to keep prep dust and coating material out. Plantings and any features near the deck masked or covered. - 3
Diamond-ground prep + crack repair
Full surface prep, crack filling, edge repair near the pool waterline if needed. - 4
Basecoat application
Polyurea or flexible urethane basecoat depending on tier, rolled and back-rolled. - 5
Decorative flake + aggregate topcoat
Decorative flake broadcast into wet basecoat. After cure, scraped flat. Polyaspartic topcoat with grip aggregate broadcast in for slip resistance. - 6
Walk-through + cure
Final walk-through. Walkable in 24 hours, fully cured for swim use in 48.
Jordan questions
Common questions for Jordan homeowners.
Does a Jordan basement floor need different treatment down in the valley?
Often, yes, and it is the reason we test rather than assume. Homes on the valley floor near Sand Creek and the Minnesota River sit on ground that holds water, and those slabs push more vapor. A slab pushing vapor will lift a film coating off the floor over time. High readings get a penetrating sealer that lets the slab breathe instead. Bluff-top homes usually test dry and take the standard film system.
My Jordan house is from 1905 and the garage is detached. Can that floor be coated?
Usually, once we have looked at it. Detached garage slabs on historic lots were typically poured decades after the house, sometimes over ground that has since settled, so the assessment comes before the quote. If the concrete is sound, it coats like any other floor. If it has settled or cracked beyond hairline, we tell you that honestly and recommend a concrete contractor rather than putting a finished surface over a failing slab.
Is Jordan far enough out that you charge for travel?
No. Fifteen miles, twenty to twenty-six minutes straight down Hwy 169 from the shop in Chaska. Jordan is inside the standard service area and the drive does not change the quote.
Is a small city like Jordan worth your time for one garage?
Yes. Clear View is owner-operated and takes a finite number of projects a year rather than chasing volume, so a single garage in Jordan is a normal booking and not a favor. The one thing distance does affect is scheduling flexibility, so if a neighbor is considering the same work, mentioning it can sometimes open an earlier date for both.
Will it actually be slip resistant when wet?
Yes. The polyaspartic topcoat is broadcast with grip aggregate (fine silica or polymer beads, depending on the texture level you want) that gives bare feet traction on a wet surface. Aggressive enough for safety, fine enough not to be uncomfortable.
Will it get hot in the sun?
Light color choices reflect significantly more heat than dark ones. We recommend lighter flake blends for pool decks specifically for this reason. Not as cool as some specialty acrylic pool deck coatings, but far cooler than dark stained concrete.
Does chlorine damage the coating?
Polyaspartic is chlorine tolerant at normal pool concentrations. Saltwater pool systems are also fine. Heavy chemical spills (concentrated shock, muriatic acid) should still be rinsed off promptly, same as you would for any finished surface.
What about the pool coping or waterline edge?
We coat the horizontal deck surface. The vertical pool coping (stone or concrete cap at the waterline) is a separate decision; we can talk through whether to include it during the estimate.
Can I coat a concrete deck with a stamped pattern?
Film coatings cover stamped patterns. If you want to keep the decorative pattern, the Essential sealer (also offered) preserves the look while adding chlorine and freeze-thaw protection.
How long does the install take?
Most residential pool decks are 1 to 2 days on site. Larger or premium decks take longer. We coordinate around the pool-use season; spring or fall installs are easier than mid-summer.
When can I open the pool after the install?
48 hours for walk and swim use. Full coating cure continues for a week beyond that, but the surface is functionally ready at 48.
Do you offer a warranty?
Yes. Written limited warranty, terms vary by tier, walked through during the estimate.
More in Jordan
All the services we offer in Jordan, MN.
Pool deck plus surrounding patio is a common combined install. Same prep and chemistry; we can size the visit to do both.
Restoration in Jordan
Other surfaces we work on in Jordan.
Clear View runs both sides of the business out of the same shop. If you're booking a pool deck coating in Jordan, bundle pricing applies when we restore or coat another surface in the same visit.
Pool Deck Coating elsewhere
Pool Deck Coating in nearby cities.
Same UV + chlorine-tolerant systems across the metro. If you're outside {city}, here's where else we work.
- Pool Deck Coating in Chaska, MN
- Pool Deck Coating in Chanhassen, MN
- Pool Deck Coating in Eden Prairie, MN
- Pool Deck Coating in Bloomington, MN
- Pool Deck Coating in Edina, MN
- Pool Deck Coating in Minnetonka, MN
- Pool Deck Coating in Shakopee, MN
- Pool Deck Coating in Prior Lake, MN
- Pool Deck Coating in Waconia, MN
- Pool Deck Coating in Victoria, MN
- Pool Deck Coating in Plymouth, MN
- Pool Deck Coating in Excelsior, MN
- Pool Deck Coating in Minnetrista, MN
Get a quote
Ready for a pool deck coating install in Jordan?
Tell us about your pool deck. We'll get back with quote details for Jordan within one business day.
- Free on-site measurement
- Written limited warranty
- No subcontractors, no upsells